ABS settings
Slicer settings for printing ABS filament on the Bambu Lab H3C. Nozzle temperature, bed temperature, fan speed, retraction, and print speed — sourced from official slicer profiles.
Recommended settings (0.4 mm brass nozzle)
Nozzle temp245°C230–260°C range
Bed temp60°C55–70°C range
Fan speed60%Min 0%
Print speed100 mm/sStarting point
Retraction0.4 mmAt 40 mm/s
Nozzle0.4 mmbrass
Source: Official profile. ✓ Verified against official profile.
All nozzle sizes
0.4 mm nozzle
| Filament | Nozzle temp | Bed temp | Fan | Speed | Retraction | Source |
|---|---|---|---|---|---|---|
| Bambu ABS Bambu Lab | 245°C 230–260°C | 60°C 55–70°C | 60% /0% | 100 mm/s | 0.4 mm @ 40 mm/s | Official profile |
| Bambu ABS-GF Bambu Lab | 245°C 230–260°C | 60°C 55–70°C | 100% /0% | 100 mm/s | 0.5 mm @ 40 mm/s | Official profile |
0.6 mm nozzle
| Filament | Nozzle temp | Bed temp | Fan | Speed | Retraction | Source |
|---|---|---|---|---|---|---|
| Bambu ABS-GF Bambu Lab | 245°C 230–260°C | 60°C 55–70°C | 100% /0% | 100 mm/s | 0.5 mm @ 40 mm/s | Official profile |
0.8 mm nozzle
| Filament | Nozzle temp | Bed temp | Fan | Speed | Retraction | Source |
|---|---|---|---|---|---|---|
| Bambu ABS-GF Bambu Lab | 245°C 230–260°C | 60°C 55–70°C | 100% /0% | 100 mm/s | 0.5 mm @ 40 mm/s | Official profile |
Tips for printing ABS on the Bambu Lab H3C
- ABS warps significantly without an enclosure — this printer is open-frame; use a draft shield or enclosure accessory.
- Minimize fan cooling — high fan speeds cause layer cracking in ABS.
- Increase bed temperature gradually if warping occurs: try 105–110°C.
- ABS fumes — print in a ventilated area.